Fabric expansion joint configurator
Configure your fabric expansion joint
Select the design, enter the dimensions and the flange connection, choose a standard flange or enter the drilling of your counter flange, then add the operating data. The 3D view shows flange and hole pattern to scale. You receive a technical configuration sheet with drawing as PDF. Our engineers design the joint and send you a quotation.
- Free and without obligation
- Reviewed by our engineers
- PDF drawing with hole pattern
- Made to measure
Which design and which size?
Select cross section and design, then enter the inside dimension of the duct and the installation length (face to face). All dimensions in millimetres.
Cross section
Design
Dimensions
With a standard flange, the flange height results from the flange outside diameter and the inside diameter.
How is the joint connected?
Choose a standard flange or enter the drilling of your counter flange. Both ends receive the same hole pattern. If one end differs, please add a note in the remarks.
The belt is bolted radially with one row of holes on each clamping surface. Enter hole diameter and maximum pitch, or leave the belt undrilled to drill it on site using the backing bar as template.
The belt is tightened onto the pipe stub with clamps over each seat. The clamps are included in the delivery.
Two clamps per side for higher pressure or large nominal sizes.
Standard flanges matching the inside diameter
resets bolt, hole pattern and pitch to the recommended design.
Undrilled: the holes are drilled during installation, using the backing bar as template.
Which equipment do you need?
Define the scope of supply and add a flow liner and insulation pillow if required.
Scope of supply
Scope of delivery: belt with clamps.
Options
The insulation pillow rests on the flow liner and can only be selected together with it.
Under which conditions does the joint operate?
The more complete your data, the more precisely we can design the layer build-up and movement capacity. All fields are optional, we will clarify missing data with you.
Medium, temperature, pressure
Enter positive pressure as a positive value and negative pressure as a negative value, e.g. −25 mbar.
Movements
Installation
Review and send your enquiry
Check your items and add your contact details. You receive the configuration sheet with drawing immediately as PDF.
Thank you, we have received your enquiry.
We will review your configuration and get back to you with a quotation. You will also receive the configuration sheet with drawing by email.
Enquiry number